Paradyne 8610 Bedienungsanleitung PDF herunterladen (Seite 36)

6. General purpose cables are provided with this product. Special cables, which may

be required by the regulatory inspection authority for the installation site, are the

responsibility of the customer.

7. When installed in the final configuration, the product must comply with the

applicable Safety Standards and regulatory requirements of the country in which it

is installed. If necessary, consult with the appropriate regulatory agencies and

inspection authorities to ensure compliance.

8. A rare phenomenon can create a voltage potential between the earth grounds of

two or more buildings. If products installed in separate buildings are

interconnected, the voltage potential may cause a hazardous condition. Consult a

qualified electrical consultant to determine whether or not this phenomenon exists

and, if necessary, implement corrective action prior to interconnecting the products.

9. Input power to the DC voltage configurations of this product must be provided by

one of the following: (1) a National Electrical Code (NEC)/Canadian Electrical

Code (CEC) Class 2 circuit for use in North America, or (2) a certified Safety Extra

Low Voltage (SELV) /Limited Power Source (LPS) input for use in the country of

installation.

10. In addition, if the equipment is to be used with telecommunications circuits, take

the following precautions:

— Never install telephone wiring during a lightning storm.

— Never install telephone jacks in wet locations unless the jack is specifically

designed for wet locations.

— Never touch uninsulated telephone wires or terminals unless the telephone

line has been disconnected at the network interface.

— Use caution when installing or modifying telephone lines.

— Avoid using a telephone (other than a cordless type) during an electrical

storm. There may be a remote risk of electric shock from lightning.

— Do not use the telephone to report a gas leak in the vicinity of the leak.

EMI Warnings

WARNING:

This equipment has been tested and found to comply with the limits for a

Class A digital device, pursuant to Part 15 of the FCC rules. These limits are

designed to provide reasonable protection against harmful interference

when the equipment is operated in a commercial environment. This

equipment generates, uses, and can radiate radio frequency energy and, if

not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications. Operation of this equipment

in a residential area is likely to cause harmful interference in which case the

user will be required to correct the interference at his own expense.

The authority to operate this equipment is conditioned by the requirements

that no modifications will be made to the equipment unless the changes or

modifications are expressly approved by Paradyne Corporation.

1 2 ... 31 32 33 34 35 36 37 38

Keine Kommentare

Paradyne 8610 Bedienungsanleitung Seite 36