Paradyne 8610 Bedienungsanleitung PDF herunterladen (Seite 16)

496-15149

Center-Mounting the 8610 Chassis in a Rack

" Procedure

To center-mount the 8610 chassis in a rack:

1. Determine the preferred placement of the 8610 chassis in the rack. Then, mark the

appropriate locations for the mounting screws on the rack.

2. Reposition the mounting brackets to the center-mount position using the four #8-32

screws supplied with the chassis.

3. Fasten the chassis to the rack. Insert the screws through the rack and into the two

screw holes located in the center of each side of the chassis.

Repeat these steps for each succeeding 8610 chassis.

Complying with NEBS

The following must be taken into consideration for compliance with Network Equipment-

Building System (NEBS) requirements.

Connection to the CO Ground Lug

" Procedure

1. Strip back the insulation approximately 1/4- to 3/8-inch on 14 AWG copper wire.

2. Loosen the screw on the GND lug located on the rear surface at the center of the

Hotwire 8610 DSLAM cover.

3. Insert the stripped end of the wire into the open end of the GND lug and tighten the

lug’s screw. Make sure it is making contact with the stripped portion of the wire.

ESD Wrist Strap Jack

A noninsulated banana jack is located at the left front side of the Hotwire 8610 DSLAM

to provide a ground for the ESD wrist strap’s plug.

HANDLING PRECAUTIONS FOR STATIC-SENSITIVE DEVICES

This product is designed to protect sensitive components from

damage due to electrostatic discharge (ESD) during normal

operation. When performing installation procedures,

however, take proper static control precautions to

prevent damage to equipment. If you are not sure

of the proper static control precautions, contact

your nearest sales or service representative.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 37 38

Keine Kommentare

Paradyne 8610 Bedienungsanleitung Seite 16