Paradyne UIM-10/100 Bedienungsanleitung PDF herunterladen

220-0000016 rev01

UIM-10/100

Uplink Interface Module

INSTALLATION

1. Unpack and inspect the equipment.

The following components should be included:

If there is visible damage, do not attempt to connect the device; contact Customer Support at 1-877-

638-2638 (001-603-427-0600 for international customers) or [email protected].

2. Install the UIM-10/100.

Required tool for installation: Phillips screwdriver.

UIM Installation in an IP DSLAM

Affix the UIM to a Multiplexer Uplink Module (MUM).

a. Place the MUM on a flat surface with the circuit board facing up.

b. Select a port on the MUM for UIM installation; either port (1 or 2) may be used.

Although not required for operational purposes, if redundancy is desired, two UIMs

may be installed on the MUM, one in each port.

Installation Instructions

CAUTION

Net to Net Technologies strongly recommends the use of proper electrostatic discharge (ESD) precautions when

handling this equipment.

1 UIM-10/100

4 #6 Phillips Panhead Internal Locking Screws

2 #6 Phillips Beige Flathead Screws

NOTE

The UIM may be attached to a MUM that has already been in service, although you must remove the

MUM from the IP DSLAM in order to do so. Removal of a MUM from an IP DSLAM chassis that is

powered up will not affect the operational status of other modules within the chassis; it

will, however, disengage the IP DSLAM's upstream network connection.

1 2 3 4 5

Inhaltsverzeichnis

Seite 1 - UIM-10/100

220-0000016 rev01UIM-10/100Uplink Interface ModuleINSTALLATION1. Unpack and inspect the equipment.The following components should be included:If there

Seite 2

220-0000016 rev01c. Remove the blanking plate* from the selected port. d. Carefully slide the faceplate of the UIM under the lip of the MUM faceplate

Seite 3

220-0000016 rev01c. Remove the blanking plate* from the selected port. d. Carefully slide the faceplate of the UIM under the inside lip of the Mini DS

Seite 4 - Additional Information

220-0000016 rev01Additional InformationLED Indicators Regulatory ComplianceThe following regulatory compliance information applies to the UIM-10/100 a

Seite 5 - 220-0000016 rev01

220-0000016 rev01European Regulatory Compliance Information for Class A Equipment This Class A product complies with European Norm EN55022. Warning: I

Kommentare zu diesen Handbüchern

Keine Kommentare

Paradyne UIM-10/100 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Nein Paradyne UIM-10/100 herunter. Paradyne UIM-10/100 User's Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Paradyne UIM-10/100